CHANGE YOUR PAD FX ON HERCULES DJCONTROL INPULSE 200 AND 300

Since the DJControl Inpulse 200 and 300 launch, lots of you requested the ability to change the FXs affected to the FX Pads sequences.

These pads sequences are hardware coded, and we worked with Hercules DJ Team to realise this Firmware Update to propose what YOU requested.

Here’s the guide.

1- Firmware Update

Before being able to change the FX on your pads, you will need to upgrade your controllers’ firmware (Only if your firmware version is below 1.72)

Please follow the instructions of the Hercules Drivers Setup to complete your firmware update.

Disconnect your Inpulse from your computer
Download Hercules latest drivers package for your Inpulse:
Inpulse 200: Download
Inpulse 300: Download
Execute the Drivers setup and follow the instructions.
Plug your controller when asked.
The Firmware update window pops up, follow the instructions. (see picture) – If the updater doesn’t show up, unplug and plug again your controller.
When the Update is done, disconnect and reconnect your controller.
To check if your controller is Up-to-date, open the Inpulse Control Panel (shortcut is on your desktop). The Firmware version should be v1.72 (see picture)

Note that on Windows operating systems, the Hercules Drivers package will also install the Inpulse ASIO Audio Drivers.
These drivers are made to operate your controller with the lowest latency available.